The figure changes with output. Turn the amperage down and the duty cycle climbs, because the internal components are working less hard. This is why a welder can feel completely different in a busy production environment compared with occasional home workshop use: someone welding continuously through a shift needs a much higher duty cycle at their working amperage than someone doing short repair jobs a few times a week. It’s the kind of spec worth comparing properly across brands such as Kemppi and EWM, not just reading off the headline amperage figure.
A reliable, adequately sized compressed air supply is the part most first-time buyers underestimate. Undersized or contaminated air, whether from moisture, oil or an undersized compressor, is one of the most common causes of poor cut quality and shortened consumable life, so it’s worth checking a machine’s air requirements against what your compressor can actually deliver before you buy, not after.
Welding produces fume made up of fine particulates and gases, and the composition varies depending on the process, the filler material and any coatings on the base metal. Fume rises from the arc and, without adequate control, can build up in the breathing zone of anyone working nearby, which is why extraction is treated as a core part of workshop set-up rather than an optional extra.
Ambient temperature and airflow around the machine also affect real-world performance. A welder working in a hot, poorly ventilated space, or one that’s been boxed in against a wall with no clearance for its cooling fan, will hit thermal cut-out sooner than the same machine used with proper clearance in a cooler environment. Keeping vents clear and giving the unit room to breathe protects both the duty cycle you paid for and the components inside.
Our own TP Weld Tables range is designed and manufactured in-house in Yorkshire, cut on a fibre laser for tight tolerances, which is the kind of detail worth asking about wherever you’re sourcing a table, and you can see the full range via Tec Products Ltd.
Cutting capacity is usually described in terms of clean cut and maximum cut thickness, and the two are worth distinguishing. Clean cut is the thickness a machine handles with a good edge finish and reasonable speed, while maximum cut is the thickest material the machine will get through at all, usually slower and with a rougher edge. Buying with your typical material thickness in mind, rather than the thickest job you might occasionally face, generally gives a better day-to-day result.